The search for an integrated, low-profile helmet mount for action cameras is over. Built for cameras such as the GoPro, our F3 Chin Vent Camera Mount seamlessly snaps into place in the chin vent, securely holding your camera without eliminating airflow through the vent. The centered position of the mount means your helmet isn’t off balance as it would be with a side mount, and the weight of the camera is close to the center of gravity.

  • INSTALLS OVER STOCK HELMET MOUTHPIECE
  • ABS + POLYCARBONATE CONSTRUCTION
  • NO GLUE OR ADHESIVE TAPE REQUIRED
  • DESIGNED FOR ACTION CAMERAS SUCH AS GOPRO 5 AND NEWER
  • COMPATIBLE WITH GOPRO-STYLE MOUNT AND ACCESSORIES
  • LOW-PROFILE, CENTER MOUNT POSITION FOR BALANCED HELMET
  • ALLOWS FOR UP/DOWN CAMERA ANGLE ADJUSTMENT
  • HELMET VENTILATION IS NOT COMPROMISED
  • INCLUDED RETENTION TETHER ATTACHES TO CAMERA OR MOUNT
  • RETENTION TETHER LOOPS TO HELMET STRAP
  • USES EXISTING CAP NUT AND THUMB SCREW FROM CAMERA
  • KEEP THE STOCK MOUTHPIECE IN THE HELMET
  • DO NOT ATTACH THE CAMERA UNTIL MOUNT IS INSTALLED
  • PUSH MOUNT STRAIGHT INTO HELMET MOUTHPIECE
  • LISTEN FOR AUDIBLE CLICK WHEN TABS SEAT INTO PLACE
  • CONFIRM TOP AND BOTTOM TABS ARE FULLY SEATED
  • FOR CAMERA INSTALL, USE EXISTING CAP NUT AND THUMB SCREW FROM CAMERA
  • TO REMOVE, PLACE THUMB ON HELMET NOSE AND INDEX FINGER UNDER TAB
  • PULL TAB UP AND BACK WHILE PUSHING THUMB AGAINST HELMET NOSE
  • F3 Chin Vent Camera Mount

    $29.99

    Out of Stock

    SKU: 3847-000-000-000

    Out of Stock




    WARNING: This product can expose you to chemicals, which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov