• Home
  • F3 Chin Vent Camera Mount
SKU: 3847-000-000-000

F3 Chin Vent Camera Mount

1 Review
$29.99
SHARE
The search for an integrated, low-profile helmet mount for action cameras is over. Built for cameras such as the GoPro, our F3 Chin Vent Camera Mount seamlessly snaps into place in the chin vent, securely holding your camera without eliminating airflow through the vent. The centered position of the mount means your helmet isn’t off balance as it would be with a side mount, and the weight of the camera is close to the center of gravity.
  • INSTALLS IN PLACE OF STOCK HELMET MOUTHPIECE
  • ABS + POLYCARBONATE CONSTRUCTION
  • NO GLUE OR ADHESIVE TAPE REQUIRED
  • DESIGNED FOR ACTION CAMERAS SUCH AS GOPRO 5 AND NEWER
  • COMPATIBLE WITH GOPRO-STYLE MOUNT AND ACCESSORIES
  • LOW-PROFILE, CENTER MOUNT POSITION FOR BALANCED HELMET
  • ALLOWS FOR UP/DOWN CAMERA ANGLE ADJUSTMENT
  • HELMET VENTILATION IS NOT COMPROMISED
  • INCLUDED RETENTION TETHER ATTACHES TO CAMERA OR MOUNT
  • RETENTION TETHER LOOPS TO HELMET STRAP
  • USES EXISTING CAP NUT AND THUMB SCREW FROM CAMERA
  • CAP NUT INCLUDED
  • USES EXISTING THUMB SCREW FROM CAMERA

 

HOW TO USE:

 

  • REMOVE STOCK MOUTHPIECE FROM HELMET
  • PUSH TOP OR BOTTOM RELEASE TAB (BEHIND MESH) FROM INSIDE THE CHIN BAR
  • DO NOT ATTACH CAMERA UNTIL MOUNT IS INSTALLED
  • PUSH TOP IN FIRST, THEN PIVOT MOUNT DOWN TO SEAT BOTTOM TAB
  • LISTEN FOR AUDIBLE CLICK WHEN TABS SEAT INTO PLACE
  • CONFIRM TOP AND BOTTOM TABS ARE FULLY SEATED (BEHIND MESH)
  • FOR CAMERA INSTALL, USE EXISTING CAP NUT AND THUMB SCREW FROM CAMERA
  • TO REMOVE, PUSH THE TOP OR BOTTOM RELEASE TAB (BEHIND MESH) FROM INSIDE THE CHIN BAR

Ratings & Reviews

1 review

  • 4 stars
  • 0 reviews
  • 3 stars
  • 0 reviews
  • 2 stars
  • 0 reviews
  • 1 star
  • 0 reviews

???

by

Not much of a review more of a question, does this fit to older Klim F3 helmets or just the 2020 models?